Add on Heated Build Plate kit for the Wanhao Dauplictor 5, 5S and 5S printers.
With this you can now print with ABS on youur Duplicator 5.
This heated build plate/platform (HBP) improves model quality by helping to
prevent warping. As extruded plastic cools, it shrinks slightly. When this
shrinking process does not occur throughout a printed part evenly the result is
a warped part. Warping usually occurs at the edges of printed parts which can
result in lifted sides/corners.
Printing on a heated bed allows the printed part to stay warm during the printing process and allows more even shrinking of the plastic as it cools below melting point. Heated beds usually yield higher quality prints with materials such as ABS and PLA.
Extra-flat glass printing surface with beveled edges.
Aluminum heat plate for even thermal conductivity.
Silicone heating pad with top operating temperature of 100°C.
External temperature controller with independent on/off rocker switch.
Magnet retention for easy installation.
*Please note: This version of the Duplicator 5S heated build plate kit will reduce your available printing area by roughly 100mm in the X-Axis (left-to-right). Temperature controller housing color may vary depending on inventory.
Betaling en beveiliging
Je betalingsgegevens worden veilig verwerkt. We slaan geen gegevens op en hebben geen toegang tot uw gegevens.