BASF Ultracur3D Resin Cleaner

BASFSKU:29035
filler

Prijs:
Actie prijs€37,99
Voorraad:
Op voorraad. Levertijd 3-6 werkdagen

Beschrijving

Ultracur3D Resin Cleaner

The Ultracur3D Cleaner removes any uncured photopolymer resin from printed parts and is compatible with a wide variety of resins, incl. most resins of the Ultracur3D portfolio.

Cleaning Procedure
  • 1. Immerse the part in an agitated bath of Ultracur3D Cleaner for a maximum of 10 minutes. Typical cleaning time is recommended between 5 to 8 minutes. Some require cleaning below 5 minutes.
  • 2. Rinse with 2-propanol for additional 1-3 minutes
  • 3. 2-propanol can be blown off with pressured air or parts can be dried at ambient temperature. For accelerated drying heat the part for approximately 10 minutes at 60 °C (140 °F)
 

Ultracur3D Cleaner is non-harmful, non-flammable at room temperature and can be heated up to 50 °C to increase cleaning efficiency. This cleaner is suitable for industrial part washing and cleaning equipment.

 

Ultracur3D® Cleaner can normally be used until it contains about 10-20% of resin, or until the cleaning performance is noticeably reduced. After this, it should be disposed according to local regulations.

Material Properties
  • Liquid Color: Blue
  • pH value: 7 (25 °C)
  • Melting Point: > 50 °
  • Boiling Point: > 100 °C
  • Vapour Pressure: 0.017 hPa (20 °C)
  • Density: 1.09 g/cm3 (20 °C)
  • Viscosity @ 20 °C: mPa·s (cP) 5

10943__BASF__001.jpg

Betaling en beveiliging

American Express Apple Pay Google Pay iDEAL PayPal Shop Pay Union Pay

Je betalingsgegevens worden veilig verwerkt. We slaan geen gegevens op en hebben geen toegang tot uw gegevens.

Op basis van jou intreresses

Recently viewed