Bondtech HeatLink 24v 50W Heater

Bondtech HeatLink 24v 50W Heater

Have it your way!

This 24v 50W Heater cartridge and cable uses a Molex micro-fit 3.0 female connector to enable extending it with one of the HeatLink interface cables and connect to your printer without hassle.

The HeatLink range is an alternative group of thermistors and heater cables enabled with Molex micro-fit connectors, complemented by several short interface cables for connecting to dozens of 3D printer models to bring ease of use to their owners.

HeatLink is the answer to the growing demand for powerful heaters and high temperature thermistors that are ready to use and easy to install.

Plug & Play thermistors and heaters from Bondtech.

Ready to use on ( at least ) 25 different Creality and Prusa models.

Pair a Bondtech thermistor or heater with a HeatLink interface cable to plug into any printer without soldering or crimping.

Each Interface Cable is 50mm long and will fit entirely inside the control box.

Bondtech HeatLink Interface Cables Compatibility Table HeatLink
JST XH-2 W/ LOCK HeatLink
JST XHP-2 HeatLink
JST VHR-2N HeatLink
JST SMP-02V-BC HeatLink
Molex MX-50-57-9002 HeatLink
Ferrule   Ender-6 CR-10S Pro
CR-10S Pro V2
CR-10 Max
CR-10 V2
CR-10 V3 Ender-5
Ender-5 Pro
Ender-5 Plus   i3 MK3 / S / +
i3 MK2.5 / S
i3 MK2 / S

CR-10
CR-10 mini
CR-10 S
CR-10 S4
CR-10 S5
CR-20 Pro
CR-5 Pro
CR-X
Ender-3
Ender-3 Pro
Ender-3 V2

The table above refers to connecting Bondtech HeatLink Thermistors only.